Paving slabs, MOT Type 1 sub-base, bedding mortar and jointing sand for a patio. Enter the patio size and slab size, set the joint width, and get the full material list.
Pedestrian patios only. Driveways and anywhere vehicles drive need a deeper sub-base specification than this tool assumes.
Paving slab calculator
A 4 by 3 m patio with 600 by 600 mm slabs and 10 mm joints needs 36 slabs, 2.34 tonnes of MOT Type 1, 4 bags of cement and 326 kg of sand with 10 percent waste. The calculator above works out the same list for any patio: slabs by effective area including joints, sub-base by depth, bedding by a 6:1 mix, and jointing sand by joint length.
How to use
- Enter the patio length and width.
- Pick your slab size and joint width. The joint you enter has to be the joint you lay, or the count will be short.
- Set the sub-base and bedding depths, or enter 0 for no sub-base or no bedding layer.
- Read the slabs, sub-base tonnage, cement bags, bedding sand and jointing sand.
Formula
Slabs = area / ((slab length + joint) x (slab width + joint)). A 600 mm slab with a 10 mm joint covers 610 x 610 mm, which is 2.69 slabs per square metre. Sub-base = area x depth x 1.95 tonnes per m3 for compacted MOT Type 1. Bedding = area x depth, at 200 kg of cement and 680 kg of sand per m3 for a 6:1 mix. Jointing sand = joint length per m2 x joint width x 25 mm depth x 1,600 kg per m3.
Practical tips
- Lay on a full mortar bed. Five dabs leave voids where water collects and slabs crack or rock. A 40 mm bed on 100 mm of compacted MOT Type 1 suits a pedestrian patio.
- Keep the fall away from the house. About 1:80, roughly 12 to 13 mm drop per metre, keeps surface water off the walls and the damp proof course.
- Curves and cuts need extra. The grid count is a plain rectangle. Circles, curves and cut edges need more slabs on top of the waste allowance.
- Check the joint width twice. A 600 mm slab with a 10 mm joint needs about 3 percent fewer slabs than the same slab laid tight. Across a big patio that is several slabs.
Frequently asked questions
How many paving slabs do I need?
Divide the patio area by the area of one slab plus its joint, then add 5 to 10 percent for cuts. A 4 by 3 m patio with 600 by 600 mm slabs and 10 mm joints needs about 36 slabs.
How deep should a patio sub-base be?
About 100 mm of compacted MOT Type 1 for a pedestrian patio. Driveways need 150 mm or more, often with edge restraints.
What bedding mix do paving slabs need?
A 6:1 sharp sand and cement mortar bed about 40 mm thick, laid as a full bed, not dabs.
Does this calculator cover driveways?
No. The sub-base depths here suit pedestrian patios only. Get a proper driveway specification for anything vehicles drive on.
More in the concrete calculator hub, including poured patios, sidewalks and gravel.