Concrete Ramp Calculator



Run length, sloped surface, slope percent and concrete volume for an access ramp. Enter the total rise, width and slab thickness, and check the slope against the ADA 1:12 maximum.



Planning figures only, not a code compliance certification. Landings, handrails, edge protection, cross slope and drainage also decide whether a ramp passes inspection, and local codes can be stricter than the federal baseline.





Concrete ramp calculator

A ramp climbing 24 inches at the ADA maximum slope of 1:12 needs 24 feet of run and 24.08 ft3 of concrete at 3 feet wide and 4 inches thick. The calculator above works out the same figures for any rise: run length, sloped surface length, slope percent and angle, concrete volume and bags, plus how many runs and landings the climb needs.

How to use

  1. Enter the total vertical rise from the ground to the entry landing.
  2. Enter the ramp width and slab thickness.
  3. Choose the slope: 1:12 is the ADA maximum, 1:16 and 1:20 are gentler where space allows.
  4. Read the run length, sloped surface, volume and bag count, and check the slope, width and handrail notes.
  5. If the rise is over 30 inches, the calculator splits the climb into runs with 60 inch landings between them.

Formula

Run = Rise x slope denominator. At 1:12, every inch of rise needs 12 inches of run. The sloped surface is the hypotenuse: sqrt(run squared + rise squared). Concrete volume = sloped length x width x slab thickness, plus one flat landing slab of 60 inches for every extra run.

Practical tips

  • Gentler is better than the maximum. 1:12 is a maximum, not a target. A 1:16 or 1:20 ramp is far easier to use where you have the space.
  • Count the landings in your space. A 36 inch rise at 1:12 needs 36 feet of ramp plus a 60 inch landing in the middle: the footprint is longer than the run alone.
  • Handrails go on both sides when a run rises more than 6 inches, and edge protection stops wheels slipping off the side.
  • Do not guess the rise. Measure from finished ground to the entry landing, not from the number of steps, or the run comes out short.

Frequently asked questions

How long does a wheelchair ramp need to be?

At the ADA maximum slope of 1:12, multiply the rise in inches by 12 to get the run in inches. A 24 inch rise needs 24 feet of run, before landings.

What is the maximum slope for a wheelchair ramp?

1:12, or 8.33%, to the 2010 ADA Standards section 405.2. Gentler slopes of 1:16 (6.25%) and 1:20 (5%) are easier to use.

How much concrete does a ramp need?

A 24 inch rise ramp at 1:12, 3 feet wide and 4 inches thick, needs 24.08 ft3 (0.89 yd3). The calculator works it out from your rise, width and thickness.

When does a ramp need a landing?

No single ramp run may rise more than 30 inches to ADA section 405.6, so taller climbs split into runs with level landings of at least 60 inches between them.

More in the concrete calculator hub, including stairs, sidewalks and patios.

Scroll to Top