Concrete Formwork Calculator



Wall formwork materials: plywood sheets, studs, walers, form ties and release agent. Enter the wall length and height, and get whole piece counts rounded up.



Materials planning only. This tool does not check concrete pressure on the forms, plywood strength, tie ratings or bracing. Get tall or critical formwork designed by a qualified person.





Concrete formwork calculator

A 20 by 8 ft wall needs 10 plywood sheets, 32 studs, 16 waler boards, 40 form ties and 0.43 gallons of release agent. The calculator above works out the same shopping list for any wall: form area on both sides, sheets at 32 ft2 each, studs at 16 inch spacing, walers at 24 inch rows and ties on a 2 ft grid.

How to use

  1. Enter the wall length and height.
  2. If you are building several identical walls, enter how many: the counts scale up for all of them.
  3. Read the plywood sheets, studs, waler boards, ties and release agent, all rounded up to whole pieces.
  4. Allow extra for cuts, corners and bracing on top of these counts.

Formula

Form area = 2 x length x height, because both faces of the wall need forms. Sheets = area / 32 ft2. Studs = (length / 1.33 ft + 1) per side, times two sides. Walers = (height / 2 ft) rows x (length / 10 ft) boards per row, times two sides. Ties = (length / 2 ft) x (height / 2 ft). Release agent = area / 750 ft2 per gallon.

Practical tips

  • Order whole sheets, not exact area. Cuts at corners and around openings waste plywood fast, so the rounded up count is a minimum, not a generous one.
  • Studs carry the plywood, walers carry the studs, ties carry the walers. Skipping any layer puts the full concrete pressure on the layer above it.
  • Oil the forms before the pour. Release agent at 750 ft2 per gallon stops the plywood bonding to the concrete and saves the sheets for reuse.
  • Watch tall and fast pours. Concrete pressure rises with pour height and pour rate, so a tall wall needs closer stud spacing and stronger ties than this planning tool assumes.

Frequently asked questions

How many plywood sheets do I need for a wall form?

Divide the form area on both faces by 32 ft2 per sheet. A 20 by 8 ft wall has 320 ft2 of form area, so 10 sheets.

What spacing do wall form studs use?

16 inches apart is the standard planning spacing used here, with one extra stud at the end of each side.

How many form ties does a wall need?

One tie per 2 ft by 2 ft grid point. A 20 by 8 ft wall needs 10 x 4 = 40 ties.

Does this calculator design the formwork?

No. It plans materials only. Form pressure, plywood strength, tie ratings and bracing need a qualified designer, especially for tall walls and fast pours.

More in the concrete calculator hub, including walls, columns and rebar.

Scroll to Top