Sealant tubes for concrete joints and cracks. Enter the joint length, width and depth, pick your tube size, and get a tube count with waste included.
Materials planning only. Sealant must bond two sides only so it can stretch, and deep joints need a foam backer rod to set the depth.
Concrete joint sealant calculator
100 ft of joint at 1/2 in wide by 1/4 in deep needs 10 tubes of 10.1 fl oz sealant with 10 percent waste. The calculator above works out the same count for any joint: length times width times depth, divided by the tube volume, with waste added.
How to use
- Enter the total joint length in feet or metres.
- Enter the joint width and depth.
- Pick your sealant container: 10.1 fl oz or 29 fl oz cartridge, 300 mL cartridge or 600 mL sausage.
- Read the tube count and the coverage per tube.
Formula
Sealant volume = joint length x width x depth; tubes = volume with waste / tube volume. A standard 10.1 fl oz cartridge holds 18.23 in3, a 29 fl oz cartridge holds 52.34 in3, a 300 mL cartridge holds 18.31 in3 and a 600 mL sausage holds 36.61 in3. One 10 oz tube covers 24 linear feet at a 1/4 in bead, but only about 12 feet at 1/2 in wide by 1/4 in deep.
Practical tips
- Bead size decides the tube count. A 1/2 in wide joint takes twice the sealant of a 1/4 in joint at the same depth. Measure the width properly before you buy.
- Depth should be about half the width. For a moving joint, aim for depth equal to half the width, never less than 1/4 in and never more than 1/2 in.
- Use backer rod in deep joints. A foam backer rod pressed into the joint sets the depth and stops three sided adhesion, so the sealant can stretch instead of tearing.
- Clean and dry first. Dust, oil and damp faces stop the bond. Brush the joint out and let it dry before you gun the sealant in.
Frequently asked questions
How many linear feet does one tube of sealant cover?
It depends on the bead: one 10.1 fl oz tube covers about 24 linear feet at a 1/4 in by 1/4 in bead, and about 12 feet at 1/2 in wide by 1/4 in deep.
How deep should joint sealant be?
About half the joint width, at least 1/4 in and at most 1/2 in. Deeper joints need a foam backer rod to set the depth.
What is backer rod for?
A foam cord pressed into the joint behind the sealant. It sets the depth, saves sealant, and stops the sealant bonding to the bottom, so it can stretch with the joint.
Can I seal a crack instead of a joint?
Yes, if the crack is stable and the faces are clean. A moving crack needs a flexible sealant, and a structural crack needs checking before any filler goes in.
More in the concrete calculator hub, including control joints, sealer and sidewalks.