Paving Slab Calculator




Paving slabs, MOT Type 1 sub-base, bedding mortar and jointing sand for a patio. Enter the patio size and slab size, set the joint width, and get the full material list.



Pedestrian patios only. Driveways and anywhere vehicles drive need a deeper sub-base specification than this tool assumes.




Paving slab calculator

A 4 by 3 m patio with 600 by 600 mm slabs and 10 mm joints needs 36 slabs, 2.34 tonnes of MOT Type 1, 4 bags of cement and 326 kg of sand with 10 percent waste. The calculator above works out the same list for any patio: slabs by effective area including joints, sub-base by depth, bedding by a 6:1 mix, and jointing sand by joint length.

How to use

  1. Enter the patio length and width.
  2. Pick your slab size and joint width. The joint you enter has to be the joint you lay, or the count will be short.
  3. Set the sub-base and bedding depths, or enter 0 for no sub-base or no bedding layer.
  4. Read the slabs, sub-base tonnage, cement bags, bedding sand and jointing sand.

Formula

Slabs = area / ((slab length + joint) x (slab width + joint)). A 600 mm slab with a 10 mm joint covers 610 x 610 mm, which is 2.69 slabs per square metre. Sub-base = area x depth x 1.95 tonnes per m3 for compacted MOT Type 1. Bedding = area x depth, at 200 kg of cement and 680 kg of sand per m3 for a 6:1 mix. Jointing sand = joint length per m2 x joint width x 25 mm depth x 1,600 kg per m3.

Practical tips

  • Lay on a full mortar bed. Five dabs leave voids where water collects and slabs crack or rock. A 40 mm bed on 100 mm of compacted MOT Type 1 suits a pedestrian patio.
  • Keep the fall away from the house. About 1:80, roughly 12 to 13 mm drop per metre, keeps surface water off the walls and the damp proof course.
  • Curves and cuts need extra. The grid count is a plain rectangle. Circles, curves and cut edges need more slabs on top of the waste allowance.
  • Check the joint width twice. A 600 mm slab with a 10 mm joint needs about 3 percent fewer slabs than the same slab laid tight. Across a big patio that is several slabs.

Frequently asked questions

How many paving slabs do I need?

Divide the patio area by the area of one slab plus its joint, then add 5 to 10 percent for cuts. A 4 by 3 m patio with 600 by 600 mm slabs and 10 mm joints needs about 36 slabs.

How deep should a patio sub-base be?

About 100 mm of compacted MOT Type 1 for a pedestrian patio. Driveways need 150 mm or more, often with edge restraints.

What bedding mix do paving slabs need?

A 6:1 sharp sand and cement mortar bed about 40 mm thick, laid as a full bed, not dabs.

Does this calculator cover driveways?

No. The sub-base depths here suit pedestrian patios only. Get a proper driveway specification for anything vehicles drive on.

More in the concrete calculator hub, including poured patios, sidewalks and gravel.

Scroll to Top