Cement bags and sand for wall and ceiling plaster. Enter the wall size and thickness, pick the mix, deduct openings, and get the material list with waste included.
Materials planning only. Damp, cracked or uneven backgrounds need their own specification, and no single coat should exceed about 15 mm.
Plaster calculator
A 10 by 3 m wall at 12 mm in a 1:6 mix needs 3 bags of 50 kg cement and 0.72 tonnes of sand with 10 percent waste. The calculator above works out the same list for any wall or ceiling: wet volume from area and thickness, dry volume at 1.33, then cement and sand split by your mix.
How to use
- Enter the wall length, height and plaster thickness.
- Pick one face or both faces, and deduct doors and windows in square metres.
- Pick your mix: 1:6 for internal walls, 1:4 for external walls, 1:3 for ceilings.
- Read the cement bags and sand, with waste included.
Formula
Wet volume = area x thickness. Dry volume = wet x 1.33, split by the cement to sand ratio, with cement at 1,440 kg per m3 and sand at 1,600 kg per m3. For 100 m2 at 12 mm in 1:6 that is 1.2 m3 wet, 1.60 m3 dry, about 7 bags of 50 kg cement and 1.37 m3 of sand.
Practical tips
- Never lay one coat thicker than about 15 mm. If the wall needs more, apply a first coat, scratch it, let it set, then apply the second coat.
- Match the mix to the surface. Internal walls take 12 mm in 1:6, external walls take 15 to 20 mm in 1:4, and ceilings take 6 mm in 1:3.
- Rough brickwork drinks more plaster. Uneven backgrounds and deep joints push consumption up, so the waste allowance matters more there than on a smooth wall.
- Deduct the openings. Doors and windows are wall that is not plastered. Add up their areas and enter the total, or you will over order.
Frequently asked questions
How much plaster do I need per square metre?
At 12 mm in 1:6, about 0.07 bags of 50 kg cement and 0.014 m3 of sand per square metre, before waste. The calculator works it out exactly for your thickness and mix.
What thickness should wall plaster be?
About 12 mm for internal walls, 15 to 20 mm for external walls, and 6 mm for ceilings, applied in coats of no more than about 15 mm each.
What mix should I use for plaster?
1:6 for internal walls, 1:4 for external walls, and 1:3 for ceilings and strong coats. Always follow your specification if it says otherwise.
Does this calculator cover render?
The same volume method applies to external render, but render systems, beads and finishes need their own specification, especially on damp walls.
More in the concrete calculator hub, including mortar, floor screed and concrete walls.