Tile Grout Calculator


Grout bags for any tiled floor. Enter the floor size, tile size and joint size, pick your bag, and get a bag count with waste included.



Materials planning only. Sanded grout suits joints from 1/8 in to 5/8 in wide, and the yield here is for MAPEI Keracolor S sanded grout, so check your own bag if you buy a different grout.



Tile grout calculator

A 10 ft by 10 ft floor of 12 in by 12 in tile with a 1/4 in joint at 3/8 in deep needs 1 bag of 25 lb grout with 10 percent waste. The calculator above works out the same count for any floor: joint length from the tile size, times joint width and depth, divided by the bag yield, with waste added.

How to use

  1. Enter the floor length and width in feet or metres.
  2. Enter the tile length and width, and the joint width and depth.
  3. Pick your grout bag: 25 lb or 10 lb.
  4. Read the bag count, the grout volume and the mixed weight.

Formula

Grout volume = floor area x joint length per sq ft x joint width x joint depth; bags = volume with waste / bag yield. Joint length per sq ft is 1 / tile length + 1 / tile width, so small tiles have far more joint than large ones. One 25 lb bag of sanded grout mixes to about 0.2344 ft3, which MAPEI confirms: 45 sq ft per 25 lb bag for 1 in tile at a 1/8 in joint.

Practical tips

  • Tile size decides the bag count. A floor of 1 in mosaic has about 24 ft of joint per sq ft, while 12 in tile has only 2 ft, so the same floor can need ten times the grout.
  • Use sanded grout for wide joints only. Sanded grout suits joints from 1/8 in to 5/8 in. Below 1/8 in, use unsanded grout, or the sand will not fit the joint.
  • Measure the depth in several places. Tile beds dip and rise, so the average joint depth is what matters. Measure in four or five spots and use the average.
  • Mix small batches. Grout starts to set in the bucket, so mix only what you can spread and clean off in about 30 minutes.

Frequently asked questions

How much grout do I need per sq ft?

It depends on the tile and the joint: 12 in tile with a 1/4 in joint needs about 0.0013 ft3 per sq ft, while 1 in mosaic with a 1/8 in joint needs about 0.0052 ft3 per sq ft.

What is the difference between sanded and unsanded grout?

Sanded grout has fine sand in the mix for strength in wide joints, from 1/8 in to 5/8 in. Unsanded grout is smooth and suits narrow joints below 1/8 in, where sand would not fit.

How deep should grout joints be filled?

Full depth, flush with the tile face. A shallow fill leaves a weak skin that cracks and falls out, so pack the joint full and tool it smooth.

Can I grout over old grout?

Only if the old grout is sound and clean. Rake out loose or cracked grout first, and never grout over a joint that is still damp or dusty.

More in the concrete calculator hub, including tile adhesive, mortar and paving slabs.

Scroll to Top