Control joint spacing, saw cut depth, linear feet of cuts and panel layout for a concrete slab. Enter the slab size and thickness, pick the spacing rule, and get the cut plan.
Planning layout only. Reinforcement, sub-base, mix shrinkage and curing also decide whether a slab cracks, and this tool does not design the slab.
Control joint calculator
A 20 by 20 ft slab at 4 inches thick needs joints every 10 ft, 40 linear ft of saw cuts, and 4 panels of 10 by 10 ft, cut 1 inch deep. The calculator above works out the same plan for any slab: spacing from the 24 to 36 rule, joints each way, total cut length, panel sizes, and the panel shape check.
How to use
- Enter the slab length, width and thickness.
- Pick the spacing rule: tighter at 24 times the thickness, standard at 30, widest at 36.
- Read the joint spacing, cut depth, linear feet of cuts and panel layout.
- If the panel shape warning shows, add a joint to shorten the long side.
Formula
Spacing in feet = 2 to 3 x thickness in inches (24 to 36 times the thickness), never more than 15 ft apart. Joints across the length = ceil(length / spacing) minus 1, the same across the width. Linear feet = joints across the length x width, plus joints across the width x length. Cut depth = one quarter of the thickness, never less than 1 inch.
Practical tips
- Cut early, not late. Cut as soon as the surface holds a blade without ravelling: 4 to 12 hours after finishing in warm weather, 12 to 24 hours in cold weather. Cut too late and the slab cracks where it wants.
- Keep panels close to square. No panel should be more than 1.5 times longer than wide. Long narrow panels crack across the middle whatever the spacing says.
- Stay near the tight end for crack control. The 24 times rule gives the best crack control; the 36 times rule is the widest that still counts as a plan.
- Isolate the slab from fixed objects. Walls, steps and existing slabs need isolation joint material, or the slab cracks against them as it shrinks.
Frequently asked questions
How far apart should saw cuts be in a concrete slab?
Between 24 and 36 times the slab thickness, never more than 15 ft. A 4 inch slab gets joints every 8 to 12 ft, and 10 ft is the standard pick.
How deep should control joints be cut?
At least one quarter of the slab thickness, and never less than 1 inch. A 4 inch slab gets a 1 inch deep cut.
When should I saw cut a new slab?
As soon as it holds a blade without ravelling: 4 to 12 hours after finishing in warm weather, 12 to 24 hours in cold weather, or 1 to 4 hours with an early entry saw.
Do control joints stop all cracking?
No. They decide where the slab cracks, by giving shrinkage a neat line to follow. Reinforcement, sub-base and curing still matter.
More in the concrete calculator hub, including slabs, patios and sidewalks.