Thinset bags for any tiled floor. Enter the floor size, pick your trowel notch, and get a bag count with back buttering and waste included.
Materials planning only. Coverage figures are the conservative low end of the Custom Building Products VersaBond data sheet, so the tool over orders slightly on purpose.
Tile adhesive calculator
A 200 sq ft floor laid with a 1/4 in by 3/8 in square notch trowel needs 4 bags of 50 lb thinset with 10 percent waste. The calculator above works out the same count for any floor: area divided by the coverage per bag for your trowel notch, with back buttering and waste added.
How to use
- Enter the floor length and width in feet or metres.
- Pick your trowel notch: a bigger tile needs a deeper notch.
- Tick back buttering if you are laying large format or natural stone tile.
- Pick your bag size, 50 lb or 25 kg, and read the bag count.
Formula
Bags = floor area with waste / coverage per bag for your trowel notch. Per 50 lb bag, a 3/16 in V notch covers about 95 sq ft, a 1/4 by 1/4 in square notch about 90 sq ft, a 1/4 by 3/8 in square notch about 60 sq ft, a 1/2 by 1/2 in square notch about 42 sq ft, and a 3/4 in U notch about 34 sq ft. Back buttering divides the coverage by 1.35.
Practical tips
- Notch size follows tile size. Mosaic takes a 3/16 in V notch, standard floor tile a 1/4 by 1/4 in notch, and large format tile a 1/2 by 1/2 in notch. A notch too small leaves hollow spots under the tile.
- Back butter large format and stone. Spread a thin coat on the tile back as well as the floor, or the tile will not reach full contact, and it adds about 35 percent to the thinset used.
- Check the contact. ANSI A108.5 needs at least 80 percent mortar contact in dry areas and 95 percent in wet areas and outdoors, so lift a tile now and then to check.
- Mix only what you can lay. Thinset starts to skin over in about 30 minutes, so mix half a bag at a time on a warm day.
Frequently asked questions
Which trowel do I need for 12 by 24 in tile?
A 1/2 by 1/2 in square notch trowel, plus back buttering. Large format tile needs the deeper bed for full contact.
How much thinset do I need per sq ft?
About 1 lb per sq ft with a 1/4 by 3/8 in notch, and about 1.5 lb per sq ft with a 1/2 by 1/2 in notch, before waste.
What is the difference between modified and unmodified thinset?
Modified thinset has polymers added for grip and flexibility, and suits most floors. Unmodified thinset has no polymers and is used where the tile maker or membrane maker calls for it.
Can I use thinset for wall tile?
Yes, with a smaller notch and a non sag mix. Wall tile takes a 1/4 by 1/4 in notch for standard tile, and heavy stone needs a non sag thinset so it does not slip.
More in the concrete calculator hub, including tile grout, mortar and paving slabs.