Sidewalk Calculator

Concrete for sidewalks and walkways. Enter length, width and thickness: get cubic yards, bags, control joint count and wire mesh area.



Estimates only. Sidewalks are typically poured 4 in thick. Joint spacing matches the walk width for square panels. Confirm the final order with your supplier.




Sidewalk concrete calculator

A 50 by 4 ft sidewalk poured 4 inches thick needs 2.47 cubic yards of concrete (2.72 cubic yards with 10% waste), which is 123 bags of 80 lb concrete mix. The calculator above works out the same figures for any walkway: enter the length, width and thickness, and it returns the volume, the bag count, the number of control joints, and the wire mesh area with its overlap allowance.

How to use

  1. Measure the full length of the walk and its width in feet.
  2. Enter the thickness. Pedestrian sidewalks are typically poured 4 in thick (minimum 3 in), using a 3,000 PSI mix.
  3. Choose the cross slope: 2% is the maximum recommended, 1% is the minimum for shedding water.
  4. Leave the waste margin at 10% to cover subgrade dips and spillage.
  5. Optionally add a price per cubic yard to get an estimated material cost.

Formula

Volume = Length x Width x Thickness, divided by 27 for cubic yards.

Control joints follow the square panel rule: joint spacing matches the walk width, so joints = length / width, rounded up. Wire mesh = slab area x 1.10, the extra 10% covering the mesh overlap.

Practical tips

  • Match joints to the width. A 4 ft walk gets joints every 4 ft, a 3 ft walk every 3 ft. Square panels crack the least and look the best.
  • Cut joints deep enough. Tool or saw-cut to at least one quarter of the slab thickness, or the joint is decoration and the cracks will wander.
  • Hold the 2% cross slope. Slope the walk sideways at 1 to 2% so water runs off, with 2% as the maximum for comfortable, accessible walking.
  • Thicken at driveways. Where the walk crosses a driveway, pour 5 to 6 in thick to carry vehicle weight.
  • Isolate at the house. Keep an expansion joint where the walk meets the foundation, steps or driveway so the slabs can move independently.

Frequently asked questions

How thick should a concrete sidewalk be?

4 inches is the standard for pedestrian sidewalks (minimum 3 in), poured with a 3,000 PSI mix. Step up to 5 or 6 in where vehicles will cross it.

How far apart should joints be on a sidewalk?

Match the joint spacing to the walk width to make square panels: a 4 ft walk gets joints every 4 ft. A 50 ft by 4 ft walk needs 13 control joints.

How much concrete for a 30 by 3 ft walkway?

At 4 in thick, a 30 by 3 ft walk is 30 ft3 (1.11 yd3), needing 55 bags of 80 lb mix with 10% waste, 10 control joints, and 99 ft2 of wire mesh with its overlap allowance.

Do I need wire mesh in a sidewalk?

Most residential sidewalks do fine without reinforcement, but wire mesh (or fibres in the mix) is worth adding on soft ground, tree root zones, or where vehicles cross. Allow 10% extra for the overlap.

More in the concrete calculator hub, including patios and curbs.

Scroll to Top