Sonotube Calculator

Concrete for sonotube piers and deck footings. Enter tube diameter, depth and pier count: get cubic yards, bags and a frost line check.



Estimates only. Sonotube is a brand name for cardboard pier forms (also called concrete tube or pier form). This sizes the concrete only; pier diameter and spacing for structural loads must meet your local code. Confirm quantities with your supplier.




Sonotube concrete calculator

Eight 12 in tubes at 48 in deep need 25.13 cubic feet of concrete (1.02 cubic yards with 10% waste), which is 47 bags of 80 lb concrete mix, about 6 bags per tube. The calculator above works out the same figures for any pier layout: enter the tube diameter, depth and number of piers, and it returns the volume per tube and the total in cubic yards, cubic metres and bags, with a frost line check and a gravel base allowance.

How to use

  1. Enter the tube diameter. Standard deck posts use 10 to 12 in tubes; common diameters run from 8 to 24 in.
  2. Enter the tube depth. Footings must extend below the local frost line: enter your frost depth and the calculator warns you if the tube is too shallow.
  3. Enter the number of piers.
  4. Keep the 6 in gravel base on: it is the standard allowance under the concrete.
  5. Leave the waste margin at 10% and optionally add a bag price for a cost estimate.

Formula

Volume per tube = pi x (diameter / 2) squared x depth, all in feet.

A 12 in tube at 48 in deep is pi x 0.5 squared x 4 = 3.14 ft3. Multiply by the pier count, add waste, and divide by 27 for cubic yards or by 0.60 ft3 for 80 lb bags.

Practical tips

  • Go below the frost line. IRC R403.1.4 requires exterior footings to extend below the local frost line, which ranges from near zero in warm climates to 48 to 60 in in cold ones. Confirm the exact depth with your building department.
  • Add the gravel base. Always allow 6 in of gravel under the concrete at the bottom of the hole. In this calculator, the gravel base is not taken off the concrete depth: with the gravel option on, the calculator adds the 6 in below the depth you enter and works out the concrete volume over the full depth plus 6 in, so a 48 in tube is calculated over 54 in.
  • Buy tubes long. Buy tubes 6 to 12 in longer than needed so you can level them cleanly at grade.
  • Size for the post. A common rule is tube diameter at least 3 times the post width; 10 to 12 in tubes suit standard deck posts, 14 to 16 in suit heavy beams.
  • Peel the tube above grade. Leave below-grade tube in place; peel the above-grade cardboard 24 to 48 hours after pouring for a cleaner look.

Frequently asked questions

How much concrete fits in a 12 in sonotube?

A 12 in diameter, 48 in tall tube holds 3.14 ft3 (0.12 yd3) of concrete, about 6 bags of 80 lb mix with 10% waste.

What size sonotube do I need for a deck?

Use 10 to 12 in tubes for standard deck posts and fence posts, and 14 to 16 in tubes for heavy load pier footings. Common diameters are 8, 10, 12, 14, 16, 18 and 24 in.

How deep should sonotube footings go?

Below the local frost line, or your local code minimum, whichever is deeper. A common deck rule of thumb is a minimum of 36 in, but northern frost lines run 48 to 60 in.

Is a sonotube the same as a concrete tube?

Yes. Sonotube is a brand name for cardboard fibre forms; contractors also say concrete tube or pier form for the same cylindrical footing.

More in the concrete calculator hub, including post holes and footings.

Scroll to Top