Monolithic Slab Calculator



Concrete for a slab and its perimeter footing poured as one piece. Enter the slab size, field thickness and edge beam size, and get the field slab, edge beam and total volumes with the corners counted once.



Estimates only. Footings must reach below the local frost line and suit the soil and loads, which this volume tool does not check. Confirm footing sizes against local code before pouring.





Monolithic slab calculator

A 40 by 30 ft slab at 4 inches thick with a 12 inch wide, 12 inch deep edge beam needs 490.67 ft3 (18.17 yd3) of concrete: 400 ft3 for the field slab and 90.67 ft3 for the edge beam. The calculator above works out the same split for any slab, and counts the four corners once instead of twice.

How to use

  1. Enter the slab length and width.
  2. Enter the field slab thickness, the thickness of the flat middle of the slab.
  3. Enter the edge beam width and its total depth at the perimeter, including the field thickness.
  4. Pick a waste margin and read the field volume, edge volume, total volume and bag count.
  5. Check the edge note: if the edge depth is no deeper than the field, there is no thickened edge to add.

Formula

Total = field slab + edge beam. Field slab = length x width x field thickness. Edge ring area = perimeter x edge width minus 4 x edge width squared, which removes the four corners counted twice where the beam turns. Edge beam = ring area x (edge depth minus field thickness).

Practical tips

  • Do not add slab and footing volumes separately. Adding a full flat slab plus a full perimeter footing counts the corners twice and the slab area under the beam twice. This calculator counts each part once.
  • Edge depth is the total depth. A 12 inch edge on a 4 inch slab adds 8 inches of extra depth, not 12: the top 4 inches are already in the field slab.
  • One pour means no cold joint between slab and footing, but it also means the whole pour must be ready at once: plan trucks and labour for the full volume.
  • Check frost depth. The edge beam must reach below the local frost line, or the slab heaves in winter. The calculator sizes volume, not footing depth.

Frequently asked questions

What is a monolithic slab?

A slab and its perimeter footing poured as one piece: a flat field slab with a deeper edge beam around the outside, cast in a single pour with no joint between them.

How much concrete does a monolithic slab need?

A 40 by 30 ft slab at 4 inches with a 12 inch edge needs 490.67 ft3 (18.17 yd3) before waste, or 539.73 ft3 (19.99 yd3) with 10% waste, which is 900 bags of 80 lb mix.

Why subtract the corners?

The edge beam runs around the perimeter, so each corner square belongs to two sides at once. Multiplying perimeter by edge width counts those four squares twice; subtracting 4 x edge width squared counts them once.

Is a monolithic slab the same as a slab plus footings?

The concrete ends up in the same shape, but a monolithic pour casts it all at once, while separate footings are poured first and the slab second, with a joint between them.

More in the concrete calculator hub, including slabs, footings and driveways.

Scroll to Top