Self Levelling Compound Calculator



Bags of self levelling compound from floor area and average thickness. Uses the manufacturer kg per m2 per mm method, with an adjustable rate and 20 kg, 25 kg and 50 lb bags.



Estimates only. Always check the consumption rate on your own bag: products vary, and the product data sheet governs. Prime porous concrete first, or the compound can pin hole.





Self levelling compound calculator

A 20 m2 floor at 5 mm thick needs 8 bags of 25 kg compound at the default rate of 1.7 kg per m2 per mm with 10% waste. The calculator above works out the same figure for any floor: enter the room size and average thickness, check the rate on your bag, and get bags, weight and volume.

How to use

  1. Enter the room length and width.
  2. Enter the average thickness, not the thinnest spot: average the shallow and deep ends for a sloping floor.
  3. Check the consumption rate on your bag and type it in if it differs from the 1.7 default.
  4. Pick your bag size and waste margin, then read the bag count, weight and coverage per bag.

Formula

Weight = Area x Thickness x consumption rate. The rate is in kg per m2 per mm, so a 20 m2 floor at 5 mm with a 1.7 rate needs 20 x 5 x 1.7 = 170 kg. Bags = weight with waste / bag size. One bag covers bag size / (rate x thickness) m2 at that thickness.

Practical tips

  • Average the thickness honestly. A floor that runs from 2 mm to 8 mm averages 5 mm, but a single deep dip needs more than the average suggests: measure the dip separately.
  • Respect the maximum single pour depth. If the deepest spot is deeper than your product allows in one layer, lay it in two layers instead of one thick one.
  • Prime first. Porous concrete drinks the water out of the compound and leaves pin holes; a primer coat stops that.
  • Work fast and from the far corner. Self levelling compound starts to set in minutes, so mix and pour without stopping, working towards the door.

Frequently asked questions

How many bags of self levelling compound do I need?

A 20 m2 floor at 5 mm needs 8 bags of 25 kg at the 1.7 kg per m2 per mm rate with 10% waste. The calculator works it out from your exact floor size and thickness.

What is the coverage of one bag?

It depends on thickness. A 25 kg bag at 1.7 kg per m2 per mm covers 2.94 m2 at 5 mm, or 4.90 m2 at 3 mm. Thicker layers cover less area per bag.

Is self levelling compound the same as screed?

No. Screed is a sand and cement layer mixed on site and laid by hand. Self levelling compound is a bagged, pourable product that flows flat on its own and is dosed by the manufacturer’s kg per m2 per mm rate.

How thick can self levelling compound go?

Most products lay from a feather edge up to about 10 mm in one pour, with some deep fill products going thicker. Check your product data sheet: going past the maximum in one pour causes cracking and poor curing.

More in the concrete calculator hub, including floor screed, slabs and sealer.

Scroll to Top