How Thick Should a Concrete Driveway Be? 4 vs 5 vs 6 Inches Explained

Cross-section view of a concrete driveway showing the concrete slab thickness, steel reinforcement and compacted MOT Type 1 subbase layers

How Thick Should a Concrete Driveway Be?

Too thin and the slab cracks under the first heavy delivery van. Too thick and you pour money into concrete you will never need. This guide settles it with a simple choice: 100mm, 125mm or 150mm, matched to the vehicles you actually park.

The short answer: For most UK homes, 100mm (4 inches) of concrete on a properly compacted subbase handles family cars and light vans with ease. Choose 125mm (5 inches) if you regularly park a large SUV, campervan or loaded trailer. Go to 150mm (6 inches) with steel reinforcement for motorhomes, box vans or regular commercial deliveries.

Why Thickness Matters More Than Strength

Many people obsess over the concrete grade and ignore the depth. That is backwards. Thickness is the single biggest factor in how much load a slab can carry. Bending strength grows much faster than thickness: double the depth and you roughly quadruple the bending strength. A modest grade at the right depth always beats a strong grade poured too thin.

A deeper slab also spreads each wheel load wider, so the ground sees less pressure: less settlement, fewer cracks and a longer working life.

The Three Standard Thicknesses

Match your situation to one of these three options. There is no need to guess.

Thickness Metric Best for Reinforcement
4 inches 100mm Family cars, small SUVs, light vans Mesh optional but wise
5 inches 125mm Large SUVs, campervans, caravans, occasional heavy loads Wire mesh recommended
6 inches 150mm Motorhomes, box vans, commercial vehicles, regular deliveries Steel mesh or rebar essential

100mm (4 inches): the standard family driveway

This is the minimum for any driveway that carries vehicles, and it is plenty for most households. A typical family car weighs around 1.5 to 2 tonnes, which a 100mm slab on a good subbase handles comfortably. If your driveway sees two cars and the weekly shop, stop here.

125mm (5 inches): the safe middle ground

That extra 25mm adds a surprising amount of strength for a modest increase in concrete. Choose this for a large SUV, campervan or caravan, or where delivery vans cross the drive regularly. Many contractors use 125mm as their default because it covers future changes, such as a heavier vehicle later, without a rebuild.

150mm (6 inches): heavy duty

Motorhomes, horseboxes, box vans and anything commercial need 150mm, always with reinforcement. The concrete alone is strong at this depth, but steel mesh or rebar is what stops shrinkage and temperature cracks from spreading. Daily heavy loading rather than occasional use is what calls for this specification.

Which Concrete Grade to Order in the UK

UK concrete uses strength classes written as two numbers, such as C25/30. The first is the cylinder strength and the second the cube strength, both in megapascals. Here is how the common grades line up for driveways:

Grade Suitability for driveways
C20/25 Not recommended for external driveways. It lacks the frost resistance UK winters demand, so the surface can scale and flake within a few seasons.
C25/30 The common minimum for a domestic driveway. Fine for cars and light vans when the subbase and thickness are right.
C28/35 (PAV1) The correct air entrained pavement specification for a UK domestic drive. Tiny air bubbles give freezing water room to expand, which greatly improves frost resistance.
C32/40 (PAV2) The heavy duty pavement specification. Choose it for 150mm slabs, commercial vehicles or anywhere de-icing salt is used.

When you ring a ready mix supplier, ask for an air entrained pavement mix rather than just a strength number. PAV1 suits a standard family drive and PAV2 suits heavier use. If the supplier only offers standard grades, C25/30 is the minimum to accept, and C32/40 is the safer pick for 125mm and 150mm slabs.

The Subbase Is Half the Job

A thick slab on a poor subbase will still fail. The subbase spreads the load, stops the slab rocking and keeps groundwater away from the underside of the concrete.

The standard build up for a UK domestic driveway is 150mm of well compacted MOT Type 1 granular subbase, laid in layers and compacted with a plate compactor or roller. MOT Type 1 is a crushed stone aggregate specified under Clause 803 of the Specification for Highway Works. It locks together tightly when compacted, which is exactly what you want under concrete.

On soft or clay ground, lay a geotextile membrane on the soil before the stone. It stops the subbase sinking into the mud. Never pour concrete straight onto topsoil or loose fill: it will settle and the slab will crack with it.

Reinforcement and Joints

Concrete is strong in compression but weak in tension, which is why slabs crack as they shrink and temperatures change. Reinforcement does not stop the first hairline crack, but it holds the slab together and stops cracks opening up.

For a 100mm driveway, a sheet of steel wire mesh is cheap insurance. For 125mm and especially 150mm slabs, treat mesh or rebar as mandatory. Keep the steel in the upper half of the slab on chairs or spacers, never lying on the subbase.

Just as important are contraction joints. Cut or form joints to roughly a quarter of the slab depth, spaced about 3 metres apart in both directions. These planned lines let the concrete crack neatly along straight joints instead of wandering across the surface.

Worked Example: A Typical UK Driveway

Take a typical UK driveway measuring 6 metres by 3 metres.

At 100mm thick: Volume = 6 x 3 x 0.10 = 1.8 cubic metres. Add 10 percent for waste and uneven ground: 1.8 x 1.10 = 1.98, so about 2.0 cubic metres. In 25kg bags (0.0117 cubic metres each): 2.0 / 0.0117 = 171 bags. In 20kg bags (0.0094 each): 2.0 / 0.0094 = 213 bags.

At 150mm thick: Volume = 6 x 3 x 0.15 = 2.7 cubic metres. Add 10 percent: 2.97, so about 3.0 cubic metres, which needs 257 of the 25kg bags.

A driveway this size sits in the awkward zone: mixing 171 bags by hand is a huge job, so most people order ready mix or a minimix load. Run your own measurements through our slab concrete calculator before ordering.

For cost, multiply the bag count by the current price per bag, or get a quote per cubic metre from a ready mix supplier and compare. Ready mix usually wins past about 1.5 cubic metres.

Mistakes That Ruin Driveways

The most common failures have nothing to do with the grade:

  • Pouring onto unprepared soil with no compacted subbase
  • Skipping contraction joints, then wondering why random cracks appear
  • Adding extra water to make the mix easier to spread, which weakens the surface
  • Parking too early. Keep cars off for at least 7 days, and heavy vehicles off for 28 days
  • Forgetting drainage. Aim for a gentle fall of around 1 in 60 away from the house so water never ponds

We cover these and more in our guide to common DIY concrete mistakes.

Frequently Asked Questions

What is the minimum thickness for a concrete driveway in the UK?

100mm (4 inches) on 150mm of compacted MOT Type 1 is the minimum for cars and light vans. Anything thinner suits only footpaths and patios.

Can I park a van on a 100mm driveway?

A light van used occasionally is fine. If a heavier van parks there daily, step up to 125mm or 150mm with reinforcement. Daily heavy loading is what separates a driveway that lasts from one that cracks.

Do I need rebar in my driveway?

For 150mm slabs, yes. For 100mm and 125mm, steel wire mesh is strongly recommended. The cost is small compared with replacing a cracked drive.

How long before I can drive on a new concrete driveway?

Keep all vehicles off for at least 7 days. Light cars can usually use the drive after 7 to 10 days in normal weather, but wait the full 28 days before parking anything heavy.

Should I choose C25/30 or C32/40?

C25/30 is the minimum most suppliers recommend for a domestic driveway. C32/40, ideally as the air entrained PAV2 pavement mix, is better for 150mm slabs, heavy vehicles and areas treated with de-icing salt.

Conclusion

Cars and light vans need 100mm, heavier family vehicles need 125mm, and motorhomes or commercial traffic need 150mm with steel inside. Pair the right depth with 150mm of compacted MOT Type 1, an air entrained pavement mix, proper joints and a week of patience before parking.


Sources

About the author

Kaleemullah Formulas use standard geometry and published bag yields; sources are linked in each article.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top